|
Vol.11, No.3, August 2022. ISSN: 2217-8309 eISSN: 2217-8333
TEM Journal
TECHNOLOGY, EDUCATION, MANAGEMENT, INFORMATICS Association for Information Communication Technology Education and Science |
Comparison of the Results of Various Methodologies for Evaluating the Ergonomic Workload of a Worker During the Performance of a Work Task
Naqib Daneshjo, Albert Mareš, Peter Malega, Jakub Kóňa, Michal Jankovič
© 2022 Naqib Daneshjo, published by UIKTEN. This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License. (CC BY-NC-ND 4.0)
Citation Information: TEM Journal. Volume 11, Issue 3, Pages 1275-1281, ISSN 2217-8309, DOI: 10.18421/TEM113-36, August 2022.
Received: 01 June 2022. Revised: 01 August 2022.
Abstract:
The article describes the analysis of a work operation on a virtual model of a production workplace. In order for the virtual workplace to correspond to reality as much as possible, 3D scanning was used to create a digital model of the part that the worker is manipulating. Tecnomatix Jack software was used to create a virtual workplace model and simulate worker movements. The operation was analyzed by four different methods, namely RULA analysis, OWAS analysis, Comfort Assessment analysis and Lower Back analysis. The results of all analyzes for the same task show that the job is not properly designed and it is necessary to propose workplace changes to eliminate the identified problems.
Keywords – ergonomics, operator, workplace, Tecnomatix Jack, RULA, OWAS, LBA, CA. |
|
----------------------------------------------------------------------------------------------------------- ----------------------------------------------------------------------------------------------------------- |