|
Vol.11, No.1, February 2022. ISSN: 2217-8309 eISSN: 2217-8333
TEM Journal
TECHNOLOGY, EDUCATION, MANAGEMENT, INFORMATICS Association for Information Communication Technology Education and Science |
Examination of Surface Quality after Drilling of Wood Plastic Composite
Zuzana Mitaľová, František Botko, Juliána Litecká, Dušan Mitaľ
© 2022 Zuzana Mitaľová, published by UIKTEN. This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License. (CC BY-NC-ND 4.0)
Citation Information: TEM Journal. Volume 11, Issue 1, Pages 323-327, ISSN 2217-8309, DOI: 10.18421/TEM111-40, February 2022.
Received: 11 January 2022. Revised: 09 February 2022.
Abstract:
Presented article with machining (specifically drilling technology) of composite materials is based on Wood-Plastic Composite, in short WPC (as a minimum substitute for wood in interior / exterior applications). Experiment is focusing on selected technological parameters of machining (spindle speed and tool feed rate) on the characteristics of created surface. Surface cut zone quality – surface topography is examined by contact profilometry (as commonly available methods) and optical methods. The results of the experiments point to the disadvantages of these composite materials and the basic aspects influencing the quality of surfaces after machining is the inhomogeneity of the material.
Keywords – Wood Plastic Composite, drilling, machinability, mechanical properties. |
|
----------------------------------------------------------------------------------------------------------- ----------------------------------------------------------------------------------------------------------- |