|
Vol.9, No.4, November 2020. ISSN: 2217-8309 eISSN: 2217-8333
TEM Journal
TECHNOLOGY, EDUCATION, MANAGEMENT, INFORMATICS Association for Information Communication Technology Education and Science |
Evaluation of Stainless Steel AISI 316Ti Corner Joints Quality Produced by Tungsten Inert Gas Welding
Dominika Botkova, Frantisek Botko, Zuzana Mitalova, Vladimir Simkulet, Maros Somsak
© 2020 Frantisek Botko, published by UIKTEN. This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License. (CC BY-NC-ND 4.0)
Citation Information: TEM Journal. Volume 9, Issue 4, Pages 1475-1479, ISSN 2217-8309, DOI: 10.18421/TEM94-20, November 2020.
Received: 25 September 2020. Revised: 26 October 2020.
Abstract:
Welding is one of the most common ways of creating permanent joints in various industries. It is important to constantly look for ways to increase the quality of welds and look for optimal conditions to achieve a quality joint. The presented article is focused on the evaluation of the quality of weldments made of AISI 316Ti material created by TIG technology with additional material and without additional material. The parameter that changed was the welding current. HV hardness measurements and macroscopic weld evaluation were used to evaluate the quality of the welded joint.
Keywords –welding, stainless steel, welding current, hardness, quality. |
|
----------------------------------------------------------------------------------------------------------- ----------------------------------------------------------------------------------------------------------- |