|
Vol.9, No.1, February 2020. ISSN: 2217-8309 eISSN: 2217-8333
TEM Journal
TECHNOLOGY, EDUCATION, MANAGEMENT, INFORMATICS Association for Information Communication Technology Education and Science |
Reduction of Tubes Diameter by the Die and Mandrel in Simulation Software
Dušan Šuťák, Michal Hatala, Michaela Dilýová, František Botko, Robert Poklemba
© 2020 František Botko, published by UIKTEN. This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License. (CC BY-NC-ND 4.0)
Citation Information: TEM Journal. Volume 9, Issue 1, Pages 380‐385, ISSN 2217-8309, DOI: 10.18421/TEM91-52, February 2020.
Received: 19 December 2019. Revised: 07 February 2020.
Abstract:
The paper deals with the area of problems and solutions of cold drawing of a tube. This process is simulated with the help of Deform 3D software. The introduction includes solvability of the current state of affairs. The chapter material and methods consist of characteristics of the current state of production, preparation of pipes before drawing and design of the used material. The following chapter describes the tools that are commonly used during the drawing process. The results section shows the final simulation of deformation tube and the resulting analysis. The conclusion briefly characterizes the final objective of the contribution, the usability of these tubes and the overall application in various sectors.
Keywords –reducing, simulation, analysis, mandrel, die, tube, pipe. |
|
----------------------------------------------------------------------------------------------------------- ----------------------------------------------------------------------------------------------------------- |