|
Vol.8, No.2, May 2019. ISSN: 2217-8309 eISSN: 2217-8333
TEM Journal
TECHNOLOGY, EDUCATION, MANAGEMENT, INFORMATICS Association for Information Communication Technology Education and Science |
Use of Modern Software Systems for Design and Realization of Prototype of Three-dimensional Model
Naqib Daneshjo, Erika Dudáš Pajerská, Zuzana Hajduova, Cristian Dan Stratyinski, Mirwais Danishjoo
© 2019 Naqib Daneshjo, published by UIKTEN. This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License. (CC BY-NC-ND 4.0)
Citation Information: TEM Journal. Volume 8, Issue 2, Pages 346-353, ISSN 2217-8309, DOI: 10.18421/TEM82-05, May 2019.
Received: 14 January 2019.
Abstract:
The work includes an overview of modern software systems suitable for prototype design of complex technical field products as well as serial production support. The introductory part of the thesis includes a research of computer-aided systems for engineering designs, control system designs, electronics as well as the chip itself with a control algorithm. Greater attention is paid to the more detailed analysis of the electronically switched engine, its mechanical design, its electronic engagement as well as its control. Brushless DC Electric Motor (BLDC) motors are most commonly used in small unmanned aircrafts, helicopters and n-clovers. In the practical part of the thesis is described the own design of equipment for testing and calibration of BLDC engines. Own methods of controlling and scanning BLDCs are described through Field-programmable Gate Arrays (FPGAs) and Multipoint Control Units (MCUs). The proposed system offers parallel control and testing of two BLDC engines.
Keywords – three-dimensional model, FPGA, BLDC, electric motor control. |
|
----------------------------------------------------------------------------------------------------------- ----------------------------------------------------------------------------------------------------------- |